- #ICOM RS BA1 REMOTE 4SHARED SERIAL#
- #ICOM RS BA1 REMOTE 4SHARED DRIVER#
- #ICOM RS BA1 REMOTE 4SHARED WINDOWS 10#
If worse comes to worse I can always try to help you via skype sharing my screen so that you can see my settings. Make sure the programs on the remote computer are under the proper sound card (the one that outputs sounds to your remote pc, not the virtual one used by the program) otherwise you will not hear anything. I think that if everything is connected but you cannot hear anything on the remote PC then it may something as simple as the settings for your sound card mixer. * To make sure you can connect your base PC with the physical radio from the remote PC, try to ping it via CMD or similar to make sure you can get through
#ICOM RS BA1 REMOTE 4SHARED SERIAL#
* Make sure in the device manager that under "Ports (COM & LPT)" it shows COM ports for the connection to the radio (for my IC-9100 something like Silicon Labs CP210x USB to UART Bridge) and one USB Serial Port on another port installed by the RS-BA1 program * Make sure the Firewall lets the programs through In my case with a new PC my Lan IP had changed from .xx to .yy so I had to change that in my router * Check your port forwarding on your internet router. * As mentionned I had to close HRD on the base station in order to hear the audio but you've tried that
#ICOM RS BA1 REMOTE 4SHARED WINDOWS 10#
I have set it up on windows 10 this week-end.
If I can get it to run on my machine in the next few days then I can share my settings with you and we can compare notes so to speak.
I just got a new windows 10 PC as well and am in the process of re-installing HRD and the RS-BA1 along with the Icom codec. Since it is a new PC that may be where the problem is coming from as you may need to re-set those. If you do not have a commercial firewall then I think windows may have its own. Very often the firewall of the virus program you are using on your PC will block traffic (incoming/outgoing) unless you specifically allow this program to do both, so you may want to check your firewall settings. I cannot remember as it has been a while but I assume that you may need to open some ports? If it is the case you may want to make sure that it was done. If it was working on your Vista PC as well it sounds like you are familiar with the settings of the Icom software itself as well so that should be fine as well.
So in a sense it is good news as it means it is probably a software config issue and nothing to do with hardware or the usb driver.
#ICOM RS BA1 REMOTE 4SHARED DRIVER#
The fact that you can connect with the USB codec using HRD implies that the driver is most likely installed correctly (sometimes it is a problem with people connecting the USB cable to their radio before having installed the driver).
0 kommentar(er)
